《電子技術應用》
您所在的位置:首頁 > 微波|射频 > 设计应用 > 基于功放、功分技术的微波信号源扩展方法研究
基于功放、功分技术的微波信号源扩展方法研究
2022年电子技术应用第7期
张 恺,许云鹏,陈秋菊,李 秦,柴熙源,吴丛凤,唐运盖
中国科学技术大学,安徽 合肥230026
摘要: 量子超导计算芯片的测试需要几十甚至上百路高频微波信号输入,普通微波信号源一般只有1~2个通道,远远不能满足测试需求;若集成多个信号源以扩展信号通道,不但体积庞大,成本昂贵,信号源的同步控制也是一个难题。针对上述问题,基于功放及功分技术,提出了对微波信号源的一路输出进行等功率扩展的方法,设计了集成了衰减器、功放和功分模块的信号源等幅扩展装置。利用微波信号源、频谱仪、网分等测量仪器搭建实验平台,对所设计信号源扩展装置的性能开展实验研究,同时验证基于功放、功分技术的微波信号源扩展方法。实验结果表明,所提出的方法能保证所扩展信号的中心频率、功率与源信号高度一致,各扩展通道的信号相位稳定性好,相位长期漂移控制在±1°以内,满足了量子超导计算芯片测试的需求。
中圖分類號: TN62
文獻標識碼: A
DOI:10.16157/j.issn.0258-7998.222865
中文引用格式: 張愷,許云鵬,陳秋菊,等. 基于功放、功分技術的微波信號源擴展方法研究[J].電子技術應用,2022,48(7):100-104.
英文引用格式: Zhang Kai,Xu Yunpeng,Chen Qiuju,et al. Research on microwave signal source expansion method based on power amplifer and power division techenology[J]. Application of Electronic Technique,2022,48(7):100-104.
Research on microwave signal source expansion method based on power amplifer and power division techenology
Zhang Kai,Xu Yunpeng,Chen Qiuju,Li Qin,Chai Xiyuan,Wu Congfeng,Tang Yungai
University of Science and Technology of China,Hefei 230026,China
Abstract: The test of the superconducting quantum computing chip requires dozens or even hundreds of high-frequency microwave signal inputs. The ordinary microwave signal source generally only has 1~2 channels, which is far from meeting the test requirements. If multiple signal sources are integrated to expand the signal channel, it will be not only bulky and expensive, but the synchronization control of the signal source will be also a difficult problem. Aiming at the above problems, based on the power amplifier and power division technology, in this paper,a method of equal-amplitude expansion of one output of the microwave signal source has been proposed, and a signal source equal-amplitude expansion device integrating attenuator, power amplifier and power division module has been designed. Then an experimental platform has been built with microwave signal source, spectrum analyzer, network analyzer and other measuring instruments to carry out experimental research on the performance of the designed signal source expansion device and verify the microwave signal source expansion method based on power amplifier and power division technology. The experimental results show that the proposed method can ensure that the amplitude and frequency of the extended signal are highly consistent with the source signal, and the signal phase of each extended channel can be kept stable for a long time, which meets the requirements of superconducting quantum computing chip testing.
Key words : quantum computing;chip testing;RF signal source;channel expansion;power amplifier

0 引言

    量子計算是一種遵循量子力學規律調控量子信息單元進行計算的新型計算模式[1]。量子計算機的理論模型是用量子力學規律重新詮釋的通用圖靈機[2]。從計算的效率上,由于量子力學疊加性的存在,某些已知的量子算法在處理問題時速度要大大快于傳統的電子計算機[3-4]。量子計算芯片本身的物理架構是多輸入多輸出,在芯片測試過程中,需要幾十甚至上百路高頻微波信號作為輸入[5-6]。量子超導計算芯片的測試需要幾十甚至上百路高頻微波信號輸入,普通微波信號源一般只有1~2個通道,遠遠不能滿足測試需求;若集成多個信號源以擴展信號通道,不但體積龐大,成本昂貴,信號源的同步控制也是一個難題。

    本文針對上述問題,基于功放及功分技術,提出了對微波信號源的一路輸出進行等功率擴展的方法,設計了集成了衰減器、功放和功分模塊的信號源等幅擴展裝置。利用微波信號源、頻譜儀、網分等測量儀器搭建實驗平臺,對所設計信號源擴展裝置的性能開展實驗研究,同時驗證基于功放、功分技術的微波信號源擴展方法,并對實驗結果進行了分析。




本文詳細內容請下載:http://m.tom3567.com/resource/share/2000004596




作者信息:

張  愷,許云鵬,陳秋菊,李  秦,柴熙源,吳叢鳳,唐運蓋

(中國科學技術大學,安徽 合肥230026)




wd.jpg

此內容為AET網站原創,未經授權禁止轉載。
主站蜘蛛池模板: 久久精品亚洲一区| 亚洲最大av网| 国产日本欧美在线| 久久偷窥视频| 精品欧美日韩在线| 欧美精品一区二区三区免费播放| 97国产精品视频| 91国产视频在线播放| 伊人久久大香线蕉综合75| 日韩中文字幕亚洲| 国产精品444| 色婷婷成人综合| 亚洲在线欧美| 欧美精品免费观看二区| 欧美日韩在线不卡视频| 久久亚洲午夜电影| 天天干天天操天天干天天操| 欧美国产日韩在线播放| 日韩欧美精品一区二区三区经典 | 亚洲中文字幕无码av永久| 日韩精品在在线一区二区中文| 欧洲日韩成人av| 久久国产精品久久久久V| 久久婷婷开心| 亚洲国产欧美不卡在线观看 | 精品午夜一区二区三区| 日本精品一区在线观看| 欧美在线日韩精品| 奇米影视亚洲狠狠色 | 午夜精品一区二区三区在线视频| 日本最新高清不卡中文字幕V| 久久久中文字幕| 国产精品久久色| 午夜精品视频在线观看一区二区| 婷婷久久五月天| 国产精品视频自拍| 一区二区高清视频| 欧美一级免费在线观看| 亚洲资源视频| 国产精品欧美激情| 日韩专区中文字幕|