</a>以太網" title="以太網">以太網" title="以太網">以太網接口,兩個CAN接口,RS485 接口和RS-232接口,主要用于工業,科學和測量系統.本文介紹了ISM網絡FMC模塊主要特性,方框圖,以太網方框圖以ISM網絡FMC模塊電路圖和材料清單.

The industrial networking FMC module adds key interfaces to support a wide range of industrial, scientific and measurement requirements. From dual 1588 compatible 10/100 Ethernet PHYs, to CAN, RS232, and RS485, the ISM Networking FMC can quickly get you started with either Spartan-6 or Virtex-6 based designs.

The ISM Networking FMC Module is designed to operate with any Avnet or Xilinx base board that is FMC enabled. The module uses an FMC Low Pin Count (LPC) connector to interface to the carrier board. The industrial networking FMC module adds key interfaces to support a wide range of industrial, scientific and measurement requirements.

ISM網絡FMC模塊主要特性:

Board I/O Connectors

— FMC LPC connector

— (2) 8-pin GPIO headers (one per PHY)

— 9-pin female DB9 for RS-232 communications

— RJ-45 connectors for Ethernet communications

Miscellaneous I/O Connectors

— 4-position user selectable DIP switch

— 6-pin Digilent header

— 6-pin PHY JTAG header

Memory

— EEPROM #1: used as module identification for FMC compliance

— EEPROM #2: used for EtherCAT configuration storage

Communication

— Dual IEEE 1588 compatible 10/100 Ethernet interfaces

— Dual CAN interfaces

— RS485 interface

— RS-232

圖1.ISM網絡FMC模塊外形圖

圖2.ISM網絡FMC模塊方框圖

圖3.以太網方框圖

圖4.ISM網絡FMC模塊電路圖(1)

圖5.ISM網絡FMC模塊電路圖(2)

圖6.ISM網絡FMC模塊電路圖(3)

圖7.ISM網絡FMC模塊電路圖(4)

圖8.ISM網絡FMC模塊電路圖(5)

圖9.ISM網絡FMC模塊電路圖(6)
ISM網絡FMC模塊材料清單:


詳情請見:
https://www.em.avnet.com/Support%20And%20Downloads/ism_networking_fmc_module-ug-reva062910.pdf
和
https://www.em.avnet.com/Support%20And%20Downloads/ism_networking_fmc_module-sch-reva052810.pdf
以及
https://www.em.avnet.com/Support%20And%20Downloads/ism_networking_fmc_module-bom-reva041910.pdf