</a>LED" title="LED">LED" title="LED">LED驅動器,集成了帶功率開關的電流模式升壓轉換器和四個電流沉.升壓轉換器能以80mA驅動多達48個LED,每串12個LED.LED沉并聯能提供更高電流,多達320mA.器件工作電壓5V-40V,開關頻率高達2.3MHz,每串LED匹配電流精度0.7% - 0.8%,PWM和模擬調光輸入,主要用在汽車信息娛樂系統,汽車儀表盤和汽車中心操控區.本文介紹了A8514主要特性和優勢, 方框圖,以及多種應用電路.
The A8514 is a multi-output white LED driver for small-size LCD backlighting. It integrates a current-mode boost converter with internal power switch and four current sinks. The boost converter can drive up to 48 LEDs, 12 LEDs per string, at 80 mA. The LED sinks can be paralleled together to achieve even higher LED currents, up to 320 mA. The A8514 can operate with a single power supply, from 5 to 40 V, which allows the part to withstand load dump conditions encountered in automotive systems.
The A8514 can drive an external P-FET to disconnect the input supply from the system in the event of a fault. The A8514 provides protection against output short and overvoltage, open or shorted diode, open or shorted LED pin, shorted boost switch or inductor, shorted FSET or ISET resistor, and IC overtemperature. A dual level cycle-by-cycle current limit function provides soft start and protects the internal current switch against high current overloads.
The A8514 has a synchronization pin that allows PWM switching frequencies to be synchronized in the range of 580 kHz to 2.3 MHz. The high switching frequency allows the A8514 to operate above the AM radio band.
A8514主要特性和優勢:
• Wide input voltage range of 5 to 40 V for start/stop, cold crank and load dump requirements
• Fully integrated LED current sinks and boost converter with 60 V DMOS
• Sync function to synchronize boost converter switching frequency up to 2.3 MHz, allowing operation above the AM band
• Excellent input voltage transient response
• Single resistor primary OVP minimizes VOUT leakage
• Internal secondary OVP for redundant protection
• LED current of 80 mA per channel
• Drives up to 12 series LEDs in 4 parallel strings
• 0.7% to 0.8% LED to LED matching accuracy
• PWM and analog dimming inputs
• Provides driver for external PMOS input disconnect switch
• Extensive protection against:
? Shorted boost switch or inductor
? Shorted FSET or ISET resistor
? Shorted output
? Open or shorted LED pin
? Open boost Schottky
? Overtemperature (OTP)
A8514應用:
LCD backlighting or LED lighting for:
? Automotive infotainment
? Automotive cluster
? Automotive center stack
圖1.A8514方框圖
圖2.A8514采用P-MOSFET檢測和VIN接地短路保護的應用電路圖
圖3.A8514設計案例電路圖
圖4.A8514采用精密輸入電流檢測和VSENSE接地保護的SEPIC配置應用電路圖
詳情請見:
http://www.allegromicro.com/en/Products/Part_Numbers/8514/8514.pdf
The A8514 is a multi-output white LED driver for small-size LCD backlighting. It integrates a current-mode boost converter with internal power switch and four current sinks. The boost converter can drive up to 48 LEDs, 12 LEDs per string, at 80 mA. The LED sinks can be paralleled together to achieve even higher LED currents, up to 320 mA. The A8514 can operate with a single power supply, from 5 to 40 V, which allows the part to withstand load dump conditions encountered in automotive systems.
The A8514 can drive an external P-FET to disconnect the input supply from the system in the event of a fault. The A8514 provides protection against output short and overvoltage, open or shorted diode, open or shorted LED pin, shorted boost switch or inductor, shorted FSET or ISET resistor, and IC overtemperature. A dual level cycle-by-cycle current limit function provides soft start and protects the internal current switch against high current overloads.
The A8514 has a synchronization pin that allows PWM switching frequencies to be synchronized in the range of 580 kHz to 2.3 MHz. The high switching frequency allows the A8514 to operate above the AM radio band.
A8514主要特性和優勢:
• Wide input voltage range of 5 to 40 V for start/stop, cold crank and load dump requirements
• Fully integrated LED current sinks and boost converter with 60 V DMOS
• Sync function to synchronize boost converter switching frequency up to 2.3 MHz, allowing operation above the AM band
• Excellent input voltage transient response
• Single resistor primary OVP minimizes VOUT leakage
• Internal secondary OVP for redundant protection
• LED current of 80 mA per channel
• Drives up to 12 series LEDs in 4 parallel strings
• 0.7% to 0.8% LED to LED matching accuracy
• PWM and analog dimming inputs
• Provides driver for external PMOS input disconnect switch
• Extensive protection against:
? Shorted boost switch or inductor
? Shorted FSET or ISET resistor
? Shorted output
? Open or shorted LED pin
? Open boost Schottky
? Overtemperature (OTP)
A8514應用:
LCD backlighting or LED lighting for:
? Automotive infotainment
? Automotive cluster
? Automotive center stack
圖1.A8514方框圖
圖2.A8514采用P-MOSFET檢測和VIN接地短路保護的應用電路圖
圖3.A8514設計案例電路圖
圖4.A8514采用精密輸入電流檢測和VSENSE接地保護的SEPIC配置應用電路圖
詳情請見:
http://www.allegromicro.com/en/Products/Part_Numbers/8514/8514.pdf
本站內容除特別聲明的原創文章之外，轉載內容只為傳遞更多信息，并不代表本網站贊同其觀點。轉載的所有的文章、圖片、音/視頻文件等資料的版權歸版權所有權人所有。本站采用的非本站原創文章及圖片等內容無法一一聯系確認版權者。如涉及作品內容、版權和其它問題，請及時通過電子郵件或電話通知我們，以便迅速采取適當措施，避免給雙方造成不必要的經濟損失。聯系電話：010-82306118；郵箱：aet@chinaaet.com。